Promise Technology VessRAID 1000s Series Handbuch PDF herunterladen (Seite 316)

VessRAID 1000s Series Product Manual

300

Network Connections

Each controller has an Ethernet (RJ45) Management Port connector on the back

of the enclosure. This is a Gigabit Ethernet connector designed to connect to

your network. The VessRAID becomes a node on your network like any other

PC, server or other component with an IP address.

VessRAID ships from the factory a default Management Port IP address of

192.168.0.1. You must change this address to one that will work with your

network. See “Chapter 3: VessRAID Setup” on page 25.

Figure 17.Management port connection on the RAID controller

Note that VessRAID Management Port can accept IP address assignments from

a DHCP server. Use VessRAID’s Command Line Utility (CLU) to enable this

feature. If you have not activated DHCP support but there is a DHCP server on

your network, there is a chance that it will inadvertently assign the VessRAID’s

Management Port IP address to another node. You might see a warning to this

effect on your Host PC’s monitor. If this happens, WebPAM PROe might not

connect. See your network administrator to work out a suitable arrangement.

LEDs

State

Dark Green Flashing Green

Activity No activity — Activity

Connectivity 10BaseT 100BaseT —

Connectivity

Activity LED

1 2 ... 311 312 313 314 315 316 317 318 319 320 321 ... 339 340

Keine Kommentare

Promise Technology VessRAID 1000s Series Handbuch Seite 316