
Choosing a Suitable Topology
To support different VTL market segment requirements, the VTrak E610f offers two topology options for VTL: Direct
Attached Storage (DAS) and Storage Area Network (SAN). A DAS topology (shown in Figure 1) is a lower cost approach,
suitable for small to medium scale deployments. A SAN topology is massively scalable in terms of both capacity into the
petabyte range and of performance up to multiple terabytes per hour, for large-scale backup applications with stringent
backup window requirements. With both the DAS and SAN topologies, there are High Availability (HA) options that can be
configured at the storage (VTrak) and appliance (VTL) levels for meeting different application requirements.
DAS
Figure 1. DAS topology
VTL Appliance A
VTL Appliance B
(Option for HA)
VTrak E610f
VTrak J610s
Expansion Unit(s)
In a DAS topology, the VTL applia
nces are
directly connected to the VTrak E610f through
their Fibre Channel ports.
TheVTrakE610fcanbeconnectedtoupto
fourPromiseVTrakJ610sexpansionunits.
HA Options for DAS
There are two levels of high availability options for meeting different application requirements.
Storage Level
The VTrak E610f supports dual controller modules, which offer fully redundant paths to the VTL appliance with no single
point of failure. As shown in Figure 1 above, each VTL appliance has two Fibre Channel ports, each of which can be
connected to one Fibre Channel port on each of the storage controllers.
Appliance Level
This HA option offers redundancy at the VTL appliance level for the VTL cluster. If one of the VTL appliances fails, the
other VTL appliance takes over the VTL requests from the backup clients without service interruption. In this case, an
optional VTL appliance could be installed with two Fibre Channel ports, each connected to the remaining Fibre Channel
port on each of the storage controllers.
Best Practices Guide 4
Kommentare zu diesen Handbüchern