Promise Technology SuperTrak SX6000 Bedienungsanleitung PDF herunterladen (Seite 5)

Offline Array Recovery Procedures—SuperTrak SX6000 and UltraTrak, Version 5a

5 of 34

Automatic Rebuild

[ Define Array Menu ]

[ Keys Available ]

Array No RAID Level Total Drv Capacity (MB) Status

Array 1 RAID5 3 61234 Rebuilding CH3 52%

Array 2 ----- ----- ----- -----

Array 3 ----- ----- ----- -----

Array 4 ----- ---- ----- -----

Array 5 ----- ---- ----- -----

Array 6 ----- ---- ----- -----

Note: * --Bootable Array

[ ] Up [ ] Down [ESC] Exit [Enter] Select [Space] Change Boot Drive

SuperTrak controller will attempt to rebuild the data on the failed drive. If it can, the

Define Array Menu will display Rebuilding progress and the target disk drive (above).In

this example, the drive on Channel 3 is being rebuilt and progress currently at 52 percent.

Allow the SuperTrak controller to rebuild the disk drive.

• If this action corrects the problem, return the array to service.

• If the array goes CRITICAL again and the SuperTrak controller tries to rebuild the same

disk drive, shut down the computer and remove the drive for testing, as described in

Remove a Disk Drive for Testing, below.

[ Define Array Menu ]

[ Keys Available ]

Array No RAID Level Total Drv Capacity (MB) Status

Array 1 RAID5 3 61234 Critical

Array 2 ----- ----- ----- -----

Array 3 ----- ----- ----- -----

Array 4 ----- ---- ----- -----

Array 5 ----- ---- ----- -----

Array 6 ----- ---- ----- -----

Note: * --Bootable Array

[ ] Up [ ] Down [ESC] Exit [Enter] Select [Space] Change Boot Drive

• If Rebuilding does not start, the array status will remain CRITICAL. Press the arrow

keys to highlight the critical array and press Enter to select it. The Define Array

Definition Menu appears (below).

1 2 3 4 5 6 7 8 9 10 ... 33 34

Keine Kommentare

Promise Technology SuperTrak SX6000 Bedienungsanleitung Seite 5