Promise Technology FAST TRAK100TM Bedienungsanleitung PDF herunterladen (Seite 10)

SY-P4ISR Quick Start Guide

Hardware

Installation

Step 5. CNR MR Card-CODEC OPTION (JP4)

CNR MR Card-CODEC

OPTION

Primary Secondary

JP4 Setting Open JP4 Short JP4

Step 6. RAID_IDE(IDE3,4) Function Selector

1. Short pin 1-2 enables RAID function on IDE 3,4 port.

2. Short pin 2-3 enables regular IDE, RAID function is disabled.

IDE 3,4 will function as normal IDE port (need to install Ultra Family Driver), please check

page 107.

RAID Function Enable Disable

RAID_IDE

Short pin 1-2 to

support RAID 0 or

Short pin 2-3

support Ultra

33/66/100

CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to clear

the CMOS memory.

1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This jumper

can be easily identified by its white colored cap.

2. Then put the jumper back to 1-2 to allow writing of new data into the CMOS memory.

CMOS Clearing

Clear CMOS Data Retain CMOS Data

JP5 Setting

Short pin 2-3 for

at least 5 seconds to

clear the CMOS

Short pin 1-

2 to

retain new

settings

Note: You must unplug the ATX power cable from the ATX power connector when

performing the CMOS Clear operation.

1 2 3

1 2

1 2 3

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Keine Kommentare

Promise Technology FAST TRAK100TM Bedienungsanleitung Seite 10